Alinking ALC-9451 Manual de usuario descargar pdf (Pagina 22)

20. Remove the outer packaging of the

optical cover and align the optical cover

with the gap of the PTZ Dome Camera.

Put the cover to its position, turn right to

the end, and remove the protection film.

Do not leave any fingerprints on the

cover

Note: While installing, be careful not to scratch or leave fingerprints on the optical cover.

Gloves are recommended for the installation. Dust may accumulate to the optical cover

after prolonged use and affect the image quality. A high-pressure gas spray can be used

to remove the dust. If the dust accumulation is severe, remove the optical cover, clean

with water, dry and wipe it carefully with a wiper (optical lens wiper). It is not allowed

to use any harsh solvents to clean the optical cover. A new replacement is available if the

optical cover is damaged to affect the image quality

Important!!

1. Users should carefully read the attached Hardware Installation Manual to avoid

damage to the equipment and personnel.

2. If you want to hang the camera from the ceiling, please do not affix this product to

the asbestos plate on the lightweight steel frame. The fragile asbestos plate might not

be capable of holding the weight and the camera may fall from the ceiling to injure

personnel or damage the equipment. It is recommended to secure the camera on a

rigid surface, such as wooden plate, concrete, metal surfaces. The attached screws

are used for wooden plate. Please use other appropriate screws if the camera is to be

secured to a surface made from different material.

3. When using a screw to fix the camera to the ceiling, please protect your eyes from

falling screws.

4. Reminder, you can fix the camera to the ceiling after setting the camera.

5. Do not forget to clean and maintain the camera -

Dust may adhere to the optical cover after prolonged use and affect the image

quality. Remove the optical cover, clean with water, dry and wipe it carefully with a

wiper (optical lens wiper).

After completion of the hardware installation:

1. Connect the network cable

Connect one end of the network cable (not supplied) to the network port on the

rear panel. Connect the other end to the network equipment of the user.

2. Connect to power supply

Connect the power supply (not supplied) to the power inlet. The camera will

automatically rotate. It takes about 40 seconds to activate the camera.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 92 93

Sin comentarios

Alinking ALC-9451 Manual de usuario Pagina 22